Will set up Victron BMV-712 Battery Monitor and SK12V100
1)Open Victron Connect, connect to the BMV battery monitor. Click on the settings wheel
2)
Battery Capacity: Total Ah of your bank of batteries
Charged voltage: 14.4V but note that this number should be about .1 or .2 volts below the charging voltage set in your charging device
Discharge Floor: 0%
Tail Current: 2-4% is good
Charged Detection Time: 3m
Peukert Exponent: 1.05
Charge Efficiency Factor: 99%
Current threshold: 0.10A
Time to go averaging period 3m
Battery Starts Synchronized: blue button should be to the right
State of Charge: leave alone
Synchronize SOC to 100%: Leave alone, this device will sync itself at the top of the charge
Zero Current Calibration: Leave alone
It’s wonderful to see that the practical advice shared here is having a positive impact. If you’re seeking expert assistance with programming tasks or require guidance with case study help, I’m here to provide valuable support. Whether you’re addressing complex coding issues or building a strong foundation, my goal is to help you succeed and advance in your academic pursuits. Don’t hesitate to reach out for programming assignment help. Let's continue growing and learning together.