Will set up Victron BMV-712 Battery Monitor and SK12V100
1)Open Victron Connect, connect to the BMV battery monitor. Click on the settings wheel
2)
Battery Capacity: Total Ah of your bank of batteries
Charged voltage: 14.4V but note that this number should be about .1 or .2 volts below the charging voltage set in your charging device
Discharge Floor: 0%
Tail Current: 2-4% is good
Charged Detection Time: 3m
Peukert Exponent: 1.05
Charge Efficiency Factor: 99%
Current threshold: 0.10A
Time to go averaging period 3m
Battery Starts Synchronized: blue button should be to the right
State of Charge: leave alone
Synchronize SOC to 100%: Leave alone, this device will sync itself at the top of the charge
Zero Current Calibration: Leave alone
Just setting up my Victron BMV-712 with the SK12V100. Found these settings helpful: Battery Capacity (total Ah), Charged Voltage (14.4V, adjust slightly below charger), Discharge Floor (0%), Tail Current (2-4%), Charged Detection Time (3m). Remember to tweak Peukert Exponent (1.05) and Charge Efficiency (99%). Almost as satisfying as landing a perfect run in Snow Rider ! Current threshold at 0.10A, averaging period 3m. Leaving SOC and calibration alone for now.